UNDERFLOOR HEATING SUPPLIERS AND INSTALLERS
Call a member of our team FREE on
0800 0433 195
Lines are open until 6pm Monday to Friday
Guide for Installation
The underfloor heating carbon film is easy to install, just follow these simple steps below:
1. Cover the existing timber or concrete floor with 6mm Depron insulating underlay (a double layer is recommended on floors with no insulation), tape all the joints together.
2. Lay out the carbon underfloor heating mats over the Depron, running the connecting cables along the perimeter of the room (the cables are taped to the existing sub-floor in order to give a flush finish).
3. Next the floor sensor probe is fitted in-between the carbon heating film.
4. The carbon film cold tails are then connected together at the small junction box provided.
5. The programmable thermostat is then connected to the heating system and the mains by your electrician.
6. Finally you are now ready to lay your moisture barrier and wood or laminate flooring.
